检测报告Test Report
报告编号: 20141215 第 1 页 共 6 页 Report No.: 20141215 Page 1 of 6
客户名称 : /
Client : /
客户地址 : /
Address : /
样品信息 :
Description of the submitted sample(s):
样品名称 : USB2.0
Sample Name : USB2.0
: / 样品型号
Model/Type : /
: DC2.0A 额定参数
Ratings : DC 2.0A
测试项目 : 温升测试
Test Item : Temperature rise test
环境温湿度 : 25-28℃, 63%R.H.
Surrounding : 25-28℃, 63%R.H.
样品状态 : 正常
State of Sample(s)
样品数量
Sample Quantity
制造商
Manufacturer
样品接收日期
Sample Received Date : Normal : 1 个 : 1pc : : : 2014-12-15 : Dec. 15, 2014
: 2014-12-15
: Dec. 15, 2014
: 1)UL1977:2009条款16;
2)依据客户要求。
: 1) Clause 16 of UL1977: 2009;
2) According to client’s requirements. 样品检测日期 Sample tested Date 检测要求 Test Requested。
检测报告Test Report
报告编号: 20141215 第 2 页 共 6 页 Report No.: 20141215 Page 2 of 6 设备清单:
检测结果: 合格 Test Results:PASS
测试数据请参见下页。
Test data details refer to next page.
主 检:
Tested by:
批 准: Approved by:
实验室主管 Lab Supervisor
审 核:
Reviewed by:
日 期:
Date :
检测报告Test Report
报告编号: 20141215 第 3 页 共 6 页 Report No.: 20141215 Page 3 of 6 1. 测试方法: Test procedure:
1) 应选择接线端子上有可能导致最高温度的位置进行温度测量。测试应该持续4个小时即使温度在短时间
内达到稳定。达到稳定状态是指三个连续5分钟时间间隔,温度没有进一步上升。
Temperatures shall be measured on the wiring terminals of the pole location judged most likely to result in the highest temperatures. The test is to continue for 4 hours even if stabilized temperatures are attained in a shorter period of time. A temperature is considered to be stabilized when three consecutive readings, taken at 5 minute intervals, indicate no further rise above the ambient temperature. 2) 所有触点应串联使得通过相同电流,电流为 DC2.0A 。
. 3) 测试应该在无空气对流环境温度范围为25 ±5°C (77 ±9°F)的条件下进行。测试在25°C以外的环境温度下
得到的结果,应通过增加测试的环境温度与25°C之间的偏差,调整到环境温度为25°C。 This test is to be made in a draft-free area having an ambient temperature of 25 ±5°C (77 ±9°F). Tests conducted at an ambient temperature other than 25°C are to have the test results adjusted to an ambient temperature of 25°C by adding the appropriate variation between 25°C and the ambient. 4) 样品每个触点的温升不能超过规定的30℃。
5) Each contact of the specimen must not exceed the specified temperature rise of 30 ℃. 2. 测试数据:
检测报告Test Report
报告编号: 20141215 第 4 页 共 6 页 Report No.: 20141215
Page 4 of 6
图1-
测试位置
Fig.1- Test locations
图2-
温升曲线
Fig.2- Temperature rise curve
检测报告Test Report
报告编号: 20141215 第 5 页 共 6 页 Report No.: 20141215 Page 5 of 6
样品图片 Photos of the sample
·
图3-样品
Fig.3- Sample photo
图4-
样品
Fig.4- Sample photo
*** 报告结束 *** *** End of report ***
检测报告Test Report
报告编号: 20141215 第 6 页 共 6 页 Report No.: 20141215 Page 6 of 6
测 试 报 告(Test Report)
检测报告TestReport报告编号20xx1215第1页共6页ReportNo20xx1215Page1of6客户名称Clien…
温升试验报告已知被试产品为S9M31510电压为100005400V电流为18194547A联结组标号为Yyn0出厂编号为5016…
对于电源部品认定测试测试报告要求提供测试数据及结论来料检可根据要求减少测试项目对于测试不合格品的应该表明不合格的测试项一输入特性1…
XXXX玩具制品厂SHONGSHANIATHONGTOYSMANUFACTORYFM824B07产品测试报告TESTREPORT副…